I tried that but it did nothing. I looked at all settings to see if there was any that would turn the angle settings off but found nothing. There was a period when the Y axis was active but it always defaulted to 270 degs and eventually even that was inactive.. Out of frustration I closed the page and this morning when I opened it up all three axis' were active. Weird!
I just loaded a new project and once again when I select 3D Box the angle settings are inactive. I did a save then re-opened and that did nothing. The angle on/off bars do nothing. This is beyond frustrating! Someone give me a clue 😐
Well I think I figured it out - or at least it did it for me. It CRASHED! Not once but maybe 4 times today but didn't seem to lose anything. The last time was a permanent lockup that required a reboot. What's worse is that I completely lost 5 hours of saved work. Weird was that it left the other projects alone and just blew away the one I had been working on even though I had done two saves in the last thirty minutes. Go figure. So I uninstalled it (don't remember the version - 92 something) and just installed the new 1.0.2 version. Don't know if it helps but stored it in its own SSD sector. Fortunately the project wasn't real complicated so maybe two hours to redo.
Beginners' Questions 3D angles turned off?
Inkscape.org
I had created a 3D Box earlier and when I tried to create another I discovered all x, y, z angles are turned off. How do I turn them back on?
BY clicking the icon with parallel bars beside the angles input boxes, if I've understood your problem.
I tried that but it did nothing. I looked at all settings to see if there was any that would turn the angle settings off but found nothing. There was a period when the Y axis was active but it always defaulted to 270 degs and eventually even that was inactive.. Out of frustration I closed the page and this morning when I opened it up all three axis' were active. Weird!
I just loaded a new project and once again when I select 3D Box the angle settings are inactive. I did a save then re-opened and that did nothing. The angle on/off bars do nothing. This is beyond frustrating! Someone give me a clue 😐
It works fine to me (MacOS, 10.13.6, inkscape 1.0.2). Maybe you can report it as a bug on your OS
Well I think I figured it out - or at least it did it for me. It CRASHED! Not once but maybe 4 times today but didn't seem to lose anything. The last time was a permanent lockup that required a reboot. What's worse is that I completely lost 5 hours of saved work. Weird was that it left the other projects alone and just blew away the one I had been working on even though I had done two saves in the last thirty minutes. Go figure. So I uninstalled it (don't remember the version - 92 something) and just installed the new 1.0.2 version. Don't know if it helps but stored it in its own SSD sector. Fortunately the project wasn't real complicated so maybe two hours to redo.