When I first snap a guide to the top left corner or edge of a page, the Y axis will read "0.00001", or "-0.00001", but if I grab the guide and put it back where it was (without letting go) then it snaps correctly to "0.00000". I haven't seen it happen with the X axis since I noticed the behaviour earlier this evening, and it doesn't seem to matter whether I'm creating a horizontal or vertical guide, nor whether I snap to the edge or corner. I know it's a tiny measurement that probably isn't worth worrying about, but I'd still appreciate any help in figuring this out, please, even if the answer is that I'm just being a muppet, or have messed up a setting etc. I'm running Inkscape 1.3.2 on Windows 11.
Beyond the Basics Inconsistent guide snapping behaviour
Inkscape.org
When I first snap a guide to the top left corner or edge of a page, the Y axis will read "0.00001", or "-0.00001", but if I grab the guide and put it back where it was (without letting go) then it snaps correctly to "0.00000". I haven't seen it happen with the X axis since I noticed the behaviour earlier this evening, and it doesn't seem to matter whether I'm creating a horizontal or vertical guide, nor whether I snap to the edge or corner.
I know it's a tiny measurement that probably isn't worth worrying about, but I'd still appreciate any help in figuring this out, please, even if the answer is that I'm just being a muppet, or have messed up a setting etc. I'm running Inkscape 1.3.2 on Windows 11.